Français
1, the lower the roller temperature roller temperature, the better the plasticising effect.
2, the smaller the roll distance, the better the plasticising effect.
3、Time The plasticising time should be less than 20 minutes, and the next piece is parked for 4~8 hours.
4、Capacity
5、Plasticising agent Temperature control at 70~75℃ The raw rubber moulded with plasticising agent has small elastic recovery, which can reduce the shrinkage of rubber.
2, the smaller the roll distance, the better the plasticising effect.
3、Time The plasticising time should be less than 20 minutes, and the next piece is parked for 4~8 hours.
4、Capacity
5、Plasticising agent Temperature control at 70~75℃ The raw rubber moulded with plasticising agent has small elastic recovery, which can reduce the shrinkage of rubber.
Advantages and disadvantages of opening machine plasticising Advantages.
A. Good quality of plasticised rubber, even plasticity.
B, change the rubber species is more flexible.
C, construction investment is small, plant requirements are not high
A. Good quality of plasticised rubber, even plasticity.
B, change the rubber species is more flexible.
C, construction investment is small, plant requirements are not high
Disadvantages.
A, low production efficiency
B, labour intensity
C, poor hygiene conditions
A, low production efficiency
B, labour intensity
C, poor hygiene conditions
