Français
First of all, check whether the voltage indicator is normal, the voltage between 380 ± 20 volts allowed to drive.
Second, before driving must check the size of the drum between the teeth between the drum with or without debris.
Third, check whether the lubrication system is normal, boot and then add lubricant, and every 4 hours of oil injection.
Fourth, check the cold water circulation system to ensure that the temperature of the regulation of the refining machine.
V. When switching on the machine, you must signal to your companion.
VI. Check whether the electric charging voltage is normal after switching on the machine.
Seven, check whether the brake is normal, and test the brake, allowing the drum to rotate 1-3 turns.
Eight, after the boot add material to the first small pieces of material to expand the drum, and quickly add rubber, and to prevent the rubber popping out to hurt people.
Nine, after driving, always pay attention to the drum, the temperature of the shaft tile (about 40 degrees).
Ten, the cutting spirit must be concentrated, correct posture, to prevent cuts, slip and fall, resulting in accidents.
Should pay attention to.
(1) It is strictly prohibited to drive overload.
(2) Where the rotating parts of the refiner is strictly prohibited to rely on.
(3) It is strictly prohibited to use the brake when stopping.
Second, before driving must check the size of the drum between the teeth between the drum with or without debris.
Third, check whether the lubrication system is normal, boot and then add lubricant, and every 4 hours of oil injection.
Fourth, check the cold water circulation system to ensure that the temperature of the regulation of the refining machine.
V. When switching on the machine, you must signal to your companion.
VI. Check whether the electric charging voltage is normal after switching on the machine.
Seven, check whether the brake is normal, and test the brake, allowing the drum to rotate 1-3 turns.
Eight, after the boot add material to the first small pieces of material to expand the drum, and quickly add rubber, and to prevent the rubber popping out to hurt people.
Nine, after driving, always pay attention to the drum, the temperature of the shaft tile (about 40 degrees).
Ten, the cutting spirit must be concentrated, correct posture, to prevent cuts, slip and fall, resulting in accidents.
Should pay attention to.
(1) It is strictly prohibited to drive overload.
(2) Where the rotating parts of the refiner is strictly prohibited to rely on.
(3) It is strictly prohibited to use the brake when stopping.
